| Lago AMX Pilot Notes |
| ANIMATIONS / SPECIAL KEYS |
| Aircraft Configuration | Configuration panel [Shft 1] |
| Canopy | Grey canopy lock handle (L wall) |
| Wing Spoilers | LIFT DUMP button (front panel) |
| Tailhook | Tailhook button (L eyebrow) |
| STARTING ENGINES |
| Throttle | right-click to STOP position |
| Battery switch | On (R fwd console) |
| Generator switches | On (R fwd console) |
| INV GEN switch | On (R fwd console) |
| Hydraulics switches | On (R fwd console) |
| Fuel Shut (guarded) switch | RUN (L aft console) |
| Fuel pumps switch | On (L aft console) |
| Throttle | click to START position |
| APU switch | On (L fwd console) |
| Starter switch | On, wait till Nh RPM settles around 55% (L fwd console) |
| APU switch | Off (L fwd console) |
| Anti skid switch | On (L fwd console) |
| Oxygen switch | On (seat left armrest) |
| Anti Ice switch | AUTO (R aft console) |
| Probes heat switch | On (R aft console) |
| TAKE OFF (clean config) |
| Trim | up to +5 |
| Flaps | Take off "D1" (2 notches) |
| Take off Speed | 133 kias |
| Gear | Up before 230 kias |
| LANDING (clean config, 500kg fuel) |
| Airbrakes as required | LIFT DUMP button (frnt panel) |
| Flaps | Full "D2" below 180 kias |
| Base leg Speed | 130 kias, 12 AoA units |
| Finals Speed | 120 kias, 12 AoA units |
| SHUTDOWN |
| Throttle | right-click to STOP position |
| NAV RADIOS |
| The left console NAV radio is used for VOR/ILS, the right console has the ADF and Tacan (Nav2) radios |
| HSI source selector | Select "HSI TACAN" for TACAN radio, "HSI ILS" for NAV VOR/ILS radio (R console NAV panel) |
| NAV/GPS mode switch | Select "GPS" for flightplan waypoint tracking, "NAV" for VOR tracking (R aft console SAHR panel) |
| AUTOPILOT |
| Autopilot clickspots are on the front panel Nav Data unit |
| Activate AP | "AP" button |
| GPS/VOR Tracking | "ENT" button, set NAV/GPS mode switch to "GPS" |
| Speed Hold | "X0" button, adjust kias with "CLR" button |
| Pitch Hold | "Y7" button |
| Alt Hold | "5R" button, adjust alt with "5" button, vs with "W4" button |
| Hdg Hold | "-9" button, adjust heading with HSI Heading Set knob |